6. Group Operated
This product can be operated by group control. It can be used
a control pad or remote control to operate from 1 to 8 units
simultaneously. ( Figure 17q and 17b are the connected method.
)
a. Connected the transmission box with exactly wire connection.(
Read 3.7 connected the wire for group control.)
b. Every transmission box with power supply, one of which should
be selected as the main unit.
c. Select the blind number for the main unit. ( Read 4.2.1,
setting the blind number.)
d. Setting the top and lowest position of the blind for every
unit. ( Read 4.2.2, setting for the top and lowest position.
)
e. All the infrared receivers of the units must be isolated
and covered except the main unit.
Procedure for the isolating and covering of infrared receivers,
Press the “SET” button 6 times first and press
“STOP” button simultaneously until the Red lamp
is flashed. After 10 seconds, the Red lamp will be off. The
infrared receivers are finished for the covering.
To release the covering of infrared receivers,
Press the “SET” button 6 times first and press
“STOP” button simultaneously until the Red lamp
is flashed. After 10 seconds, the Red lamp will be off. The
infrared receivers are finished to release.
|
